Thingiverse
Micro Limit Switch Mount
di paulmsam
17
Download
17
Likes
0
Makes
Needed to mount a limit switch for a project so made this :)
Its a very tight fit, but i did add holes that fit a strand of filament so that no screw is needed to hold the switch in place itself. It is a tight fix so use a pliers. With my printer it was overkill as the switch needed a reasonable amount of force to insert
It uses 3mm mounting screws
The arch printed fine on my printer, its there to allow the cables to come out either side once installed.
Its a very tight fit, but i did add holes that fit a strand of filament so that no screw is needed to hold the switch in place itself. It is a tight fix so use a pliers. With my printer it was overkill as the switch needed a reasonable amount of force to insert
It uses 3mm mounting screws
The arch printed fine on my printer, its there to allow the cables to come out either side once installed.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
