Micro Quad Box

I designed a case for my KL-EX90 which holds the quad, a few utensils below and 7 450mah 2s batteries.

Except the print you will need:

- 4-8 M3 screws (the lower compartment is fine without really) of any length
- 4 5*5mm cylindrical magnets
- 4 5*1mm cylindrical magnets (also not really needed)

I am including the Fusion 360 file if you want to change anything or make it fit your Microquad :)

Note: the handle in the lid is pretty useless... I may update this later on, but for the moment I dont care :P
Happy flying