Thingiverse
Micro Quad Box
door Karatektus
8
Downloads
5
Likes
0
Makes
I designed a case for my KL-EX90 which holds the quad, a few utensils below and 7 450mah 2s batteries.
Except the print you will need:
- 4-8 M3 screws (the lower compartment is fine without really) of any length
- 4 5*5mm cylindrical magnets
- 4 5*1mm cylindrical magnets (also not really needed)
I am including the Fusion 360 file if you want to change anything or make it fit your Microquad :)
Note: the handle in the lid is pretty useless... I may update this later on, but for the moment I dont care :P
Happy flying
Except the print you will need:
- 4-8 M3 screws (the lower compartment is fine without really) of any length
- 4 5*5mm cylindrical magnets
- 4 5*1mm cylindrical magnets (also not really needed)
I am including the Fusion 360 file if you want to change anything or make it fit your Microquad :)
Note: the handle in the lid is pretty useless... I may update this later on, but for the moment I dont care :P
Happy flying
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!