Slicer Discord
MicroLoom – 3D printable model from Thingiverse Thingiverse
Tools

MicroLoom

476 Downloads
439 Likes
2 Makes
Go to Model
A tiny loom for weaving.
Has a frame, a comb for compacting each row and a needle.

http://www.flickr.com/photos/54388270@N04/sets/72157634793760421/

There are many different ways to use this. Here's one:

Cut two short lengths of string, hold parallel, tie one set of ends together. Place knot over one tooth of the loom. Pull tight and tie the other end over the opposite knot.
Continue until all teeth have a pair of strings.

Weave under, over, under, over from side to side. Don't go around the frame. After each row, neaten up using the comb.

When finished, tie up. Slide each of the knots off of the teeth.
Category
Tools
Source
Thingiverse
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection