Slicer Discord
MicroLoom – 3D-Druckmodell von Thingiverse Thingiverse
MicroLoom – Bild 1 MicroLoom – Bild 2 MicroLoom – Bild 3 MicroLoom – Bild 4
Tools

MicroLoom

von tobyjaffey · Tools
476 Downloads
439 Likes
2 Makes
Zum Modell
A tiny loom for weaving.
Has a frame, a comb for compacting each row and a needle.

http://www.flickr.com/photos/54388270@N04/sets/72157634793760421/

There are many different ways to use this. Here's one:

Cut two short lengths of string, hold parallel, tie one set of ends together. Place knot over one tooth of the loom. Pull tight and tie the other end over the opposite knot.
Continue until all teeth have a pair of strings.

Weave under, over, under, over from side to side. Don't go around the frame. After each row, neaten up using the comb.

When finished, tie up. Slide each of the knots off of the teeth.
Kategorie
Tools
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen