Slicer Discord
MicroLoom – 3D-printbaar model van Thingiverse Thingiverse
MicroLoom – Bild 1 MicroLoom – Bild 2 MicroLoom – Bild 3 MicroLoom – Bild 4
Tools

MicroLoom

door tobyjaffey · Tools
476 Downloads
439 Likes
2 Makes
Model downloaden
A tiny loom for weaving.
Has a frame, a comb for compacting each row and a needle.

http://www.flickr.com/photos/54388270@N04/sets/72157634793760421/

There are many different ways to use this. Here's one:

Cut two short lengths of string, hold parallel, tie one set of ends together. Place knot over one tooth of the loom. Pull tight and tie the other end over the opposite knot.
Continue until all teeth have a pair of strings.

Weave under, over, under, over from side to side. Don't go around the frame. After each row, neaten up using the comb.

When finished, tie up. Slide each of the knots off of the teeth.
Categorie
Tools
Bron
Thingiverse
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie