Thingiverse
Music
Zum Modell
Microphone Echo Shield
22
Downloads
42
Likes
0
Makes
Protect your microphone signal from part of the echo of the room.
Print :
2xSidePanel
1xFrontPanel
1xMicrophoneHolder
Buy :
4 M4 10mm screw
4 M4 self-locking nuts
3 25x25cm soundproof panels
I printed the panels on their round side, with support enabled.
Assemble the panels with 10mm M4 screws and self-locking nuts.
The holes in the MicrophoneHolder piece are designed to have standard 5/8" threads. If you don't have a proper 5/8" tap, you can do as I did, and use your microphone stand as a tap to create the threads. If using PLA, the plastic is soft enough for this to work.
For the sound proof material, I used 25x25cm panels from Aliexpress : http://a.aliexpress.com/_vKiKO8
Cut 173x157mm rectangles in the panels and it will fit right into the panels, no need to glue them. (You need to make a groove in the sound proof material for the center panel).
Print :
2xSidePanel
1xFrontPanel
1xMicrophoneHolder
Buy :
4 M4 10mm screw
4 M4 self-locking nuts
3 25x25cm soundproof panels
I printed the panels on their round side, with support enabled.
Assemble the panels with 10mm M4 screws and self-locking nuts.
The holes in the MicrophoneHolder piece are designed to have standard 5/8" threads. If you don't have a proper 5/8" tap, you can do as I did, and use your microphone stand as a tap to create the threads. If using PLA, the plastic is soft enough for this to work.
For the sound proof material, I used 25x25cm panels from Aliexpress : http://a.aliexpress.com/_vKiKO8
Cut 173x157mm rectangles in the panels and it will fit right into the panels, no need to glue them. (You need to make a groove in the sound proof material for the center panel).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
