Thingiverse
Music
Ver Modelo
Microphone Echo Shield
22
Descargas
42
Likes
0
Makes
Protect your microphone signal from part of the echo of the room.
Print :
2xSidePanel
1xFrontPanel
1xMicrophoneHolder
Buy :
4 M4 10mm screw
4 M4 self-locking nuts
3 25x25cm soundproof panels
I printed the panels on their round side, with support enabled.
Assemble the panels with 10mm M4 screws and self-locking nuts.
The holes in the MicrophoneHolder piece are designed to have standard 5/8" threads. If you don't have a proper 5/8" tap, you can do as I did, and use your microphone stand as a tap to create the threads. If using PLA, the plastic is soft enough for this to work.
For the sound proof material, I used 25x25cm panels from Aliexpress : http://a.aliexpress.com/_vKiKO8
Cut 173x157mm rectangles in the panels and it will fit right into the panels, no need to glue them. (You need to make a groove in the sound proof material for the center panel).
Print :
2xSidePanel
1xFrontPanel
1xMicrophoneHolder
Buy :
4 M4 10mm screw
4 M4 self-locking nuts
3 25x25cm soundproof panels
I printed the panels on their round side, with support enabled.
Assemble the panels with 10mm M4 screws and self-locking nuts.
The holes in the MicrophoneHolder piece are designed to have standard 5/8" threads. If you don't have a proper 5/8" tap, you can do as I did, and use your microphone stand as a tap to create the threads. If using PLA, the plastic is soft enough for this to work.
For the sound proof material, I used 25x25cm panels from Aliexpress : http://a.aliexpress.com/_vKiKO8
Cut 173x157mm rectangles in the panels and it will fit right into the panels, no need to glue them. (You need to make a groove in the sound proof material for the center panel).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
