Thingiverse
Mini Spoon
von Devstroyer
91
Downloads
125
Likes
0
Makes
I needed a small spoon that can take a bigger load so I made this. Quite easy to print, but I don't recommend to go with lower detail than 0.15mm with layer height. I hope you'll enjoy it as much as I did.
If you run in any issues or just have a word to say, please don't hesitate to comment or send me a message.
If you run in any issues or just have a word to say, please don't hesitate to comment or send me a message.
Devstroyer veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
