Thingiverse
Mini Spoon
door Devstroyer
91
Downloads
125
Likes
0
Makes
I needed a small spoon that can take a bigger load so I made this. Quite easy to print, but I don't recommend to go with lower detail than 0.15mm with layer height. I hope you'll enjoy it as much as I did.
If you run in any issues or just have a word to say, please don't hesitate to comment or send me a message.
If you run in any issues or just have a word to say, please don't hesitate to comment or send me a message.
Devstroyer publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
