Thingiverse
Minimum case for Raspberry Pi Zero
by LeatherWing
8
Downloads
5
Likes
0
Makes
Just whipped this up to make sure I have measurements for the Pi Zero right and protect the traces on the back side of the board.
Print it out, slap the Pi Zero on it and heat up a paperclip and smash down the pins of the case to secure it all together. (Maybe warm up the extruder and press the pin against it?)
Print it out, slap the Pi Zero on it and heat up a paperclip and smash down the pins of the case to secure it all together. (Maybe warm up the extruder and press the pin against it?)
LeatherWing also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
