Thingiverse
Minimum case for Raspberry Pi Zero
door LeatherWing
8
Downloads
5
Likes
0
Makes
Just whipped this up to make sure I have measurements for the Pi Zero right and protect the traces on the back side of the board.
Print it out, slap the Pi Zero on it and heat up a paperclip and smash down the pins of the case to secure it all together. (Maybe warm up the extruder and press the pin against it?)
Print it out, slap the Pi Zero on it and heat up a paperclip and smash down the pins of the case to secure it all together. (Maybe warm up the extruder and press the pin against it?)
LeatherWing publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
