Thingiverse
Model Building Risers
door Rastl
3
Downloads
4
Likes
2
Makes
This is a set of risers to help with assembling models. The risers go from 1mm to 5mm and can be used in any combination to acquire the necessary height to hold a model off the table while other pieces are glued in place.
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
1mm and 2mm do not have sockets or pegs since they're too thin for that. 3mm, 4mm, and 5mm have stackers (sockets and top pegs) and toppers (sockets).
They don't snap-fit and can be angled around to hold the model in whatever configuration is needed.
Consider these the cinder blocks of model building. :)
Rastl publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
