Model Rocket Display Stand

This is a display stand for your small model rockets. There are 2 varieties I designed for you to display your rockets, one vertical display and one angled display.

You can look at the pictures to decide which one you would like to make.

For the vertical one you will need to print:
3 short legs
3 small feet
3 short leg covers
1 Upper pad - vertical
1 Lower pad - vertical
1 Vertical Support

For the angled version, you will need to print:
2 short legs
2 small feet
2 short leg covers
1 long leg
1 large foot
1 long leg cover
1 Upper pad - angled
1 Lower pad - angled
1 Angled Support
1 Pivot (or use a 2mm x 15mm long dowel pin)
2 Rear angled supports

The angled display is configured to be set from 85° to 45° in 5° increments. The angled support was designed for the maximum angle of 45°, if you decide you want to use one of the steeper angles, you will need to trim the length of the support accordingly to allow the feet of the display to set flat on the surface.