Thingiverse
Modular Frame Stabilizers
von nathanjohnson83
3
Downloads
1
Likes
0
Makes
I'd been thinking about added a some frame stabilization for a while now. I downloaded a few models from here but they were all static and didn't seem to fit my frame geometry. I I built these brackets. They use M5 bolts and nuts, with a washer in between the two PLA parts to prevent rubbing or wear. I replaced the two corner acrylic corner pieces on the left and right sides so there isn't a need for further t-nuts. The spar itself is a 18 mm wooden dowel rod. I'm hoping that it will increase my print quality.
Comments or questions are welcome.
Comments or questions are welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
