Thingiverse
MonoPrice MakerSelect LCD Relocation
von Edyck
0
Downloads
0
Likes
0
Makes
This is a mount for the LCD when case is removed. I designed to slip under the front lip ONLY if you have the support braces installed. (Assumes a 8.5mm gap)
*******THIS ASSUMES YOU HAVE A Z BRACE INSTALLED. GAP FROM TABLE TO CROSS BRACE REQUIRED******
I ordered a 3-ft, 10-pin cable for less than $10.00 for 2.
*******THIS ASSUMES YOU HAVE A Z BRACE INSTALLED. GAP FROM TABLE TO CROSS BRACE REQUIRED******
I ordered a 3-ft, 10-pin cable for less than $10.00 for 2.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
