Thingiverse
Mudkip
von xiaotian_63
32
Downloads
15
Likes
0
Makes
ABOUT:
This is an Altered model of my own of the following: (not printable) Mudkip (Read Description).
This model can be found here:
https://www.thingiverse.com/thing:4618841
https://www.prusaprinters.org/prints/112445-not-printable-mudkip-read-description
This new model is printable! With a few modifications, I solved the bed adhesion issue I had by giving the model more surface area attached to the bed. In addition, I split the model into two. this allows for the body to be printed with more infill, solving the top-heavy issue I had. I also added my "XIAO" mark to the back of the body.
PRINTING:
supports are needed
I suggest printing at .2mm of finer for both pieces.
The head is good at 15% infill, with the body being 30%
POST PRINT:
As long as you print at 100% scale or more, the pieces should just lay together. You can glue them if you desire.
This is an Altered model of my own of the following: (not printable) Mudkip (Read Description).
This model can be found here:
https://www.thingiverse.com/thing:4618841
https://www.prusaprinters.org/prints/112445-not-printable-mudkip-read-description
This new model is printable! With a few modifications, I solved the bed adhesion issue I had by giving the model more surface area attached to the bed. In addition, I split the model into two. this allows for the body to be printed with more infill, solving the top-heavy issue I had. I also added my "XIAO" mark to the back of the body.
PRINTING:
supports are needed
I suggest printing at .2mm of finer for both pieces.
The head is good at 15% infill, with the body being 30%
POST PRINT:
As long as you print at 100% scale or more, the pieces should just lay together. You can glue them if you desire.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
