Thingiverse
Mudkip
por xiaotian_63
32
Descargas
15
Likes
0
Makes
ABOUT:
This is an Altered model of my own of the following: (not printable) Mudkip (Read Description).
This model can be found here:
https://www.thingiverse.com/thing:4618841
https://www.prusaprinters.org/prints/112445-not-printable-mudkip-read-description
This new model is printable! With a few modifications, I solved the bed adhesion issue I had by giving the model more surface area attached to the bed. In addition, I split the model into two. this allows for the body to be printed with more infill, solving the top-heavy issue I had. I also added my "XIAO" mark to the back of the body.
PRINTING:
supports are needed
I suggest printing at .2mm of finer for both pieces.
The head is good at 15% infill, with the body being 30%
POST PRINT:
As long as you print at 100% scale or more, the pieces should just lay together. You can glue them if you desire.
This is an Altered model of my own of the following: (not printable) Mudkip (Read Description).
This model can be found here:
https://www.thingiverse.com/thing:4618841
https://www.prusaprinters.org/prints/112445-not-printable-mudkip-read-description
This new model is printable! With a few modifications, I solved the bed adhesion issue I had by giving the model more surface area attached to the bed. In addition, I split the model into two. this allows for the body to be printed with more infill, solving the top-heavy issue I had. I also added my "XIAO" mark to the back of the body.
PRINTING:
supports are needed
I suggest printing at .2mm of finer for both pieces.
The head is good at 15% infill, with the body being 30%
POST PRINT:
As long as you print at 100% scale or more, the pieces should just lay together. You can glue them if you desire.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
