Thingiverse
Nerf Bow
door kleinfisch
40
Downloads
28
Likes
0
Makes
This is a small, 3D printable bow to fire Nerf darts using a rubber band.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
