Thingiverse
Nerf Bow
por kleinfisch
40
Descargas
28
Likes
0
Makes
This is a small, 3D printable bow to fire Nerf darts using a rubber band.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
