Thingiverse
Nerf Bow
von kleinfisch
40
Downloads
28
Likes
0
Makes
This is a small, 3D printable bow to fire Nerf darts using a rubber band.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
Just hot glue the arm to the tube, putting the arm inline with the slot.
Then, put the rubber band on the bow.
Shoots farthest at about 45 degrees.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
