Thingiverse
Nullbits Nibble Keyboard Case
von summernipples
2
Downloads
4
Likes
0
Makes
A low profile, 2 piece case for the Nullbits Nibble DIY keyboard.
I was underwhelmed with how the RGB shines through just the acrylic plate, so I designed this case to give the RGB something to shine through, and also give the board the tiniest bit of angle.
It's intended to be used with everything installed except the bottom PCB. And original hardware should still work for mounting into the case.
I was underwhelmed with how the RGB shines through just the acrylic plate, so I designed this case to give the RGB something to shine through, and also give the board the tiniest bit of angle.
It's intended to be used with everything installed except the bottom PCB. And original hardware should still work for mounting into the case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
