Thingiverse
Nullbits Nibble Keyboard Case
door summernipples
2
Downloads
4
Likes
0
Makes
A low profile, 2 piece case for the Nullbits Nibble DIY keyboard.
I was underwhelmed with how the RGB shines through just the acrylic plate, so I designed this case to give the RGB something to shine through, and also give the board the tiniest bit of angle.
It's intended to be used with everything installed except the bottom PCB. And original hardware should still work for mounting into the case.
I was underwhelmed with how the RGB shines through just the acrylic plate, so I designed this case to give the RGB something to shine through, and also give the board the tiniest bit of angle.
It's intended to be used with everything installed except the bottom PCB. And original hardware should still work for mounting into the case.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
