Thingiverse
Nutcracker
by eKacarski
19
Downloads
25
Likes
0
Makes
Nutcracker with conical chamber
-------------------------------------------
The print takes 7.5 hours and around 125 grams of PLA
Works OK-ish for cracking walnuts size 35mm and for almonds.
I printed it in PLA but has some flex to it. If you print it from something else please tell me how it went.
You will need to sand the axle a little bit because it is too snug.
You can add spring: the pockets are for 4.5mm (I took one from automatic pen)
-------------------------------------------
The print takes 7.5 hours and around 125 grams of PLA
Works OK-ish for cracking walnuts size 35mm and for almonds.
I printed it in PLA but has some flex to it. If you print it from something else please tell me how it went.
You will need to sand the axle a little bit because it is too snug.
You can add spring: the pockets are for 4.5mm (I took one from automatic pen)
eKacarski also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
