Thingiverse
Nutcracker
door eKacarski
19
Downloads
25
Likes
0
Makes
Nutcracker with conical chamber
-------------------------------------------
The print takes 7.5 hours and around 125 grams of PLA
Works OK-ish for cracking walnuts size 35mm and for almonds.
I printed it in PLA but has some flex to it. If you print it from something else please tell me how it went.
You will need to sand the axle a little bit because it is too snug.
You can add spring: the pockets are for 4.5mm (I took one from automatic pen)
-------------------------------------------
The print takes 7.5 hours and around 125 grams of PLA
Works OK-ish for cracking walnuts size 35mm and for almonds.
I printed it in PLA but has some flex to it. If you print it from something else please tell me how it went.
You will need to sand the axle a little bit because it is too snug.
You can add spring: the pockets are for 4.5mm (I took one from automatic pen)
eKacarski publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
