Thingiverse
Offset Door Stop
por capella_ben
21
Descargas
14
Likes
0
Makes
I needed a non-standard door stop because I had a door that was higher than the bottom of some nearby cupboards.
This one hangs down 15mm below the level of the door.
Update: I have added another version of the door side that is a little stronger.
Update 2: Added a couple more combinations.
This one hangs down 15mm below the level of the door.
Update: I have added another version of the door side that is a little stronger.
Update 2: Added a couple more combinations.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!