Thingiverse
Offset Door Stop
door capella_ben
21
Downloads
14
Likes
0
Makes
I needed a non-standard door stop because I had a door that was higher than the bottom of some nearby cupboards.
This one hangs down 15mm below the level of the door.
Update: I have added another version of the door side that is a little stronger.
Update 2: Added a couple more combinations.
This one hangs down 15mm below the level of the door.
Update: I have added another version of the door side that is a little stronger.
Update 2: Added a couple more combinations.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!