Thingiverse
OpenForge OpenLOCK Wall Support
by MarcCCTx
79
Downloads
33
Likes
0
Makes
Something I noticed with the new Rampage Castles Internal support may be needed, but why print a full wall when it will never be seen? Two versions with a variation on both.
The Pass-Thru versions require the Pass-Thru Clip, used to connect something to both sides of the A-width units. (The slim pass-thru clip is used for upper floors to go between wall studs)
The Pass-Thru versions require the Pass-Thru Clip, used to connect something to both sides of the A-width units. (The slim pass-thru clip is used for upper floors to go between wall studs)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!