Thingiverse
OpenForge OpenLOCK Wall Support
door MarcCCTx
79
Downloads
33
Likes
0
Makes
Something I noticed with the new Rampage Castles Internal support may be needed, but why print a full wall when it will never be seen? Two versions with a variation on both.
The Pass-Thru versions require the Pass-Thru Clip, used to connect something to both sides of the A-width units. (The slim pass-thru clip is used for upper floors to go between wall studs)
The Pass-Thru versions require the Pass-Thru Clip, used to connect something to both sides of the A-width units. (The slim pass-thru clip is used for upper floors to go between wall studs)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!