Thingiverse
PCB Prototype Enclosure
by A_Str8
6
Downloads
1
Likes
0
Makes
Vented enclosure for 3cm x 7cm PCB prototype board. I'm using boards from (this kit.
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
A_Str8 also publishes on
71 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
