Thingiverse
PCB Prototype Enclosure
door A_Str8
6
Downloads
1
Likes
0
Makes
Vented enclosure for 3cm x 7cm PCB prototype board. I'm using boards from (this kit.
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
A_Str8 publiceert ook op
71 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
