Thingiverse
Peg
door Funderaren
2
Downloads
4
Likes
0
Makes
A peg to assemble the hilt components
In case you have no 8mm glassfiber rod you can print a bunch of these to assemble the hilt components. it will not e as durable but good to get the fitting right.
Instead of a chamfer i made guiding segment with a slightly smaller diameter on both ends.
The idea behind it is that a chamfer can guide the peg in an angle so it gets stuck. Because the guiding portion is a little bit longer than the diameter it will have good chance to guide the peg straight.
In case you have no 8mm glassfiber rod you can print a bunch of these to assemble the hilt components. it will not e as durable but good to get the fitting right.
Instead of a chamfer i made guiding segment with a slightly smaller diameter on both ends.
The idea behind it is that a chamfer can guide the peg in an angle so it gets stuck. Because the guiding portion is a little bit longer than the diameter it will have good chance to guide the peg straight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
