Thingiverse
Pi Camera Mount
von mad4x4
4
Downloads
3
Likes
1
Makes
Printed orginal design and liked the camer holder but found several problems
1) couldn't get ribbon in to slot without disconnectiong Camera
2) Piviot was poor
3) Small support shaft was thin and not connected to pivot ball and was a sloppy fit.
So took the Camera Holder and redesigned the Base and mount. - Should also print without support
1) couldn't get ribbon in to slot without disconnectiong Camera
2) Piviot was poor
3) Small support shaft was thin and not connected to pivot ball and was a sloppy fit.
So took the Camera Holder and redesigned the Base and mount. - Should also print without support
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
