Thingiverse
Pi Camera Mount
por mad4x4
4
Descargas
3
Likes
1
Makes
Printed orginal design and liked the camer holder but found several problems
1) couldn't get ribbon in to slot without disconnectiong Camera
2) Piviot was poor
3) Small support shaft was thin and not connected to pivot ball and was a sloppy fit.
So took the Camera Holder and redesigned the Base and mount. - Should also print without support
1) couldn't get ribbon in to slot without disconnectiong Camera
2) Piviot was poor
3) Small support shaft was thin and not connected to pivot ball and was a sloppy fit.
So took the Camera Holder and redesigned the Base and mount. - Should also print without support
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
