Thingiverse
Pi Camera Mount
von bitwi
0
Downloads
1
Likes
0
Makes
I needed this, so I made it.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
