Thingiverse
Pi Camera Mount
por bitwi
0
Descargas
1
Likes
0
Makes
I needed this, so I made it.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
Fits a 1&1/8 inch diameter dowel. Uses M2 screws/nuts.
----
Notes:
The back of my mount piece looks bad, because I forgot to floor it.
Also, there was a camera component very close to the mount holes.
I didn't need to use bolts in my print because the holes were very tight (too tight).
I've fixed these things in the uploaded STL.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
