Slicer Discord
Pic Stick – 3D-Druckmodell von Thingiverse Thingiverse

Pic Stick

4 Downloads
4 Likes
0 Makes
Zum Modell
This is the Pic Stick!

I've seen similar ones at the store made out of wire. We needed one NOW and didn't want to travel 30 minutes to closest store. So Pic Stick was born! I use a standard shish kebab stick and the size seems to be 4.5 mm in diameter. Smaller sticks can be used with a little tape wrapped around them to make it fit snug.

How to use the Pic Stick?

Get the right size shish kebab stick that you wish to use. you can cut / break them to any length. Use the flat end of the stick to slide the Pic Stick onto it and the pointy end will go into a foam ball or block inside of a planter. (you can even just use the stick to add a note or picture into a flower arrangement) Next you will place the picture, note, craft item in between the clamp like end. If it is two tight you can slide your finger nail into it to open it up. Depending on your printer, if you have any stringing, you may need a razor blade to clear the stringing before attempting to put the picture into the ho
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen