Slicer Discord
Pic Stick – Modelo 3D imprimible de Thingiverse Thingiverse

Pic Stick

4 Descargas
4 Likes
0 Makes
Ver Modelo
This is the Pic Stick!

I've seen similar ones at the store made out of wire. We needed one NOW and didn't want to travel 30 minutes to closest store. So Pic Stick was born! I use a standard shish kebab stick and the size seems to be 4.5 mm in diameter. Smaller sticks can be used with a little tape wrapped around them to make it fit snug.

How to use the Pic Stick?

Get the right size shish kebab stick that you wish to use. you can cut / break them to any length. Use the flat end of the stick to slide the Pic Stick onto it and the pointy end will go into a foam ball or block inside of a planter. (you can even just use the stick to add a note or picture into a flower arrangement) Next you will place the picture, note, craft item in between the clamp like end. If it is two tight you can slide your finger nail into it to open it up. Depending on your printer, if you have any stringing, you may need a razor blade to clear the stringing before attempting to put the picture into the ho
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección