Thingiverse

Play Spool Riser

von D_Rogers

2 Downloads

0 Likes

0 Makes

I have a spool that is just a bit too wide for the stock Printrbot Play spool holder. It prevented the spool from rotating freely, which caused layer shift on a couple prints. I designed these risers to quickly snap onto the stock spool holder. The front block has a raised lip to prevent the spool from sliding off. I used supports, but it may not be needed if your machine can handle bridging.

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat