Thingiverse
PopSocket Car Mount
von dcwsaranac
0
Downloads
5
Likes
0
Makes
After finding no good mounts for my vehicle, I created my own.
After creating a minimalist PopSocket interface that I liked, I made a minimalist arm and attachment for my Escape.
The arm extends sideways at a 30 degree angle from the base that anchors to the face of my console. To minimize the alterations to the console, I set to heat-set thread inserts into the console for 3mm screws. The console faceplate was thin, so I glued a PLA block to the back of the faceplate to set the inserts.
After creating a minimalist PopSocket interface that I liked, I made a minimalist arm and attachment for my Escape.
The arm extends sideways at a 30 degree angle from the base that anchors to the face of my console. To minimize the alterations to the console, I set to heat-set thread inserts into the console for 3mm screws. The console faceplate was thin, so I glued a PLA block to the back of the faceplate to set the inserts.
dcwsaranac veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
