Thingiverse
PopSocket Car Mount
door dcwsaranac
0
Downloads
5
Likes
0
Makes
After finding no good mounts for my vehicle, I created my own.
After creating a minimalist PopSocket interface that I liked, I made a minimalist arm and attachment for my Escape.
The arm extends sideways at a 30 degree angle from the base that anchors to the face of my console. To minimize the alterations to the console, I set to heat-set thread inserts into the console for 3mm screws. The console faceplate was thin, so I glued a PLA block to the back of the faceplate to set the inserts.
After creating a minimalist PopSocket interface that I liked, I made a minimalist arm and attachment for my Escape.
The arm extends sideways at a 30 degree angle from the base that anchors to the face of my console. To minimize the alterations to the console, I set to heat-set thread inserts into the console for 3mm screws. The console faceplate was thin, so I glued a PLA block to the back of the faceplate to set the inserts.
dcwsaranac publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
