Thingiverse

Pro DnD Case V7 Split

von sgxguru

12 Downloads

5 Likes

0 Makes

This is a quick remix of Berko's DnD Case V7 split using this SPL splitter:
https://htmlpreview.github.io/?https://raw.githubusercontent.com/arpruss/stlutils/master/split.html#

Thanks to Alexander Pruss http://www.thingiverse.com/arpruss/ for the simple JS tool

See the original at https://www.thingiverse.com/thing:3500077

There are no other changes but the single file made it nearly impossible to print. I hope you find it helpful.

Instructions from the original:

Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Speed: 50-55mm/s
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
Walls: Sides - i used 2 on mine.... Ive had no i

dice dice box dice tray dnd dnd mini dnd prop dnd miniature dragon dragons dungeons and dragons Dungeons Dragons dungeon dnd gaming gaming dice pencil pencil holder storage Storage Box tabletop tabletop gaming dice dice box dice tray dnd dnd mini dnd prop dnd miniature dragon dragons dungeons and dragons Dungeons Dragons dungeon dnd gaming gaming dice pencil pencil holder storage Storage Box tabletop tabletop gaming

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

Supports nötig

Einteilig Supports nötig

Supports 2/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker