Thingiverse
Pro DnD Case V7 Split
by sgxguru
12
Downloads
5
Likes
0
Makes
This is a quick remix of Berko's DnD Case V7 split using this SPL splitter:
https://htmlpreview.github.io/?https://raw.githubusercontent.com/arpruss/stlutils/master/split.html#
Thanks to Alexander Pruss http://www.thingiverse.com/arpruss/ for the simple JS tool
See the original at https://www.thingiverse.com/thing:3500077
There are no other changes but the single file made it nearly impossible to print. I hope you find it helpful.
Instructions from the original:
Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Speed: 50-55mm/s
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
Walls: Sides - i used 2 on mine.... Ive had no i
https://htmlpreview.github.io/?https://raw.githubusercontent.com/arpruss/stlutils/master/split.html#
Thanks to Alexander Pruss http://www.thingiverse.com/arpruss/ for the simple JS tool
See the original at https://www.thingiverse.com/thing:3500077
There are no other changes but the single file made it nearly impossible to print. I hope you find it helpful.
Instructions from the original:
Amount of Plastic used: 75 - 80% of a 1KG roll of PLA (including support material)
Nozzle: 0.4mm @ 195C
Layer Height: 0.2mm
Bed: 60C - for the larger prints, A thin layer UHU glue stick helps!
Speed: 50-55mm/s
Infill: 15% - if you go lower in %, (eg 10%) you will need to increase top layers to 5 to
remove Bumps. on the slide lid, 100% infill is best!
Walls: Top 4 to 5 - Depending on your infill! above 20% around 3-4 is fine!
Walls; Bottom - 2 to 3 layers.
Walls: Sides - i used 2 on mine.... Ive had no i
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
