Thingiverse
Toys & Games
Voir le modèle
PS3 Controller Holder
379
Téléchargements
428
Likes
11
Makes
Easy to print holder for two PS3 controllers.
Put it all together with contact glue.
Notes:
1. You may need to sand a little bit to fit the holders into the base.
2. Take care to have the wide part of the base plate to the rear.
3. Note that the Controller plates go in upside down. The chamfered edge should face downwards.
Put it all together with contact glue.
Notes:
1. You may need to sand a little bit to fit the holders into the base.
2. Take care to have the wide part of the base plate to the rear.
3. Note that the Controller plates go in upside down. The chamfered edge should face downwards.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
