Thingiverse
Toys & Games
Model downloaden
PS3 Controller Holder
379
Downloads
428
Likes
11
Makes
Easy to print holder for two PS3 controllers.
Put it all together with contact glue.
Notes:
1. You may need to sand a little bit to fit the holders into the base.
2. Take care to have the wide part of the base plate to the rear.
3. Note that the Controller plates go in upside down. The chamfered edge should face downwards.
Put it all together with contact glue.
Notes:
1. You may need to sand a little bit to fit the holders into the base.
2. Take care to have the wide part of the base plate to the rear.
3. Note that the Controller plates go in upside down. The chamfered edge should face downwards.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
