Thingiverse
Pumpkin
by gear-ratio
10
Downloads
7
Likes
0
Makes
Created for Halloween decorations and easy to print giveaways, these two pumpkins can be scaled and easily printed without supports. If printed with orange filament and finer layer thickness (0.10mm) not much post processing is required.
I have been successful printing with infills as low as 10%, but this may vary based on printer and selected shell thickness.
Material: ABS or PLA (Orange)
Infill: >10%
Layer Height: 0.1mm (to limit post processing)
Nozzle: 0.4 Diameter
I have been successful printing with infills as low as 10%, but this may vary based on printer and selected shell thickness.
Material: ABS or PLA (Orange)
Infill: >10%
Layer Height: 0.1mm (to limit post processing)
Nozzle: 0.4 Diameter
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
