Thingiverse
Pumpkin
por gear-ratio
10
Descargas
7
Likes
0
Makes
Created for Halloween decorations and easy to print giveaways, these two pumpkins can be scaled and easily printed without supports. If printed with orange filament and finer layer thickness (0.10mm) not much post processing is required.
I have been successful printing with infills as low as 10%, but this may vary based on printer and selected shell thickness.
Material: ABS or PLA (Orange)
Infill: >10%
Layer Height: 0.1mm (to limit post processing)
Nozzle: 0.4 Diameter
I have been successful printing with infills as low as 10%, but this may vary based on printer and selected shell thickness.
Material: ABS or PLA (Orange)
Infill: >10%
Layer Height: 0.1mm (to limit post processing)
Nozzle: 0.4 Diameter
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
