Thingiverse
Raspberry Pi camera angle mount case
von Deagol
41
Downloads
14
Likes
0
Makes
This is a camera mount for the Raspberry Pi camera, that allows you to mount it in a square leg of an Ikea Lack printer enclosure, or simmilar, pointing down at a 45º angle. Perfect for a Printer monitoring or remote control system like Octopi.
The camera and the cover are held in place by six M2x4 screws. Although you could do with only 3 really.
The case itself can be attached to the table leg with double sided tape, or two dots of Sugru or hot glue. (Please forgive the crappy sticky tape of the picture... I was just trying to find the right height)
The camera and the cover are held in place by six M2x4 screws. Although you could do with only 3 really.
The case itself can be attached to the table leg with double sided tape, or two dots of Sugru or hot glue. (Please forgive the crappy sticky tape of the picture... I was just trying to find the right height)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
