Thingiverse
Raspberry Pi Zero Case - Flipped Header
von CreatorD
9
Downloads
2
Likes
0
Makes
Whoopsy doopsy! I accidentally soldered the header on the wrong side of my new Pi Zero. Remixed the Adafruit Raspberry Pi Zero Case to match.
Original: https://www.thingiverse.com/thing:1165227
4 columns were added to the cover, as to keep the Pi secure when plugging cables into the header. The side of the case with the ribbon cable port was extended by 1 mm to make the Pi fit better.
I recommend printing the case with 100% infill to prevent the columns from being hollow inside, as that seems to make them weak.
Original: https://www.thingiverse.com/thing:1165227
4 columns were added to the cover, as to keep the Pi secure when plugging cables into the header. The side of the case with the ribbon cable port was extended by 1 mm to make the Pi fit better.
I recommend printing the case with 100% infill to prevent the columns from being hollow inside, as that seems to make them weak.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
