Thingiverse
Raspberry Pi ZeroW case
von ulrikk
13
Downloads
6
Likes
0
Makes
I really liked Superrei's design. Really nice with the hinge. Since I needed a case to lift with my drone without wide open ports I closed the HDMI and one USB port.
In the final end I would add another 0.5 mm on th hinge side to make a smaller gap in the hinge.I was also looking to make it thinner to reduce weight, but I couldn't figure it out how do it in Fusion.
Finality I intend to spray the inside with graphite to screen the Zero to reduce interference with the DJI drone.
In the final end I would add another 0.5 mm on th hinge side to make a smaller gap in the hinge.I was also looking to make it thinner to reduce weight, but I couldn't figure it out how do it in Fusion.
Finality I intend to spray the inside with graphite to screen the Zero to reduce interference with the DJI drone.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
